> cat /proc/kmsg
<4>Total Flash size: 2048K with 35 sectors
<4>Scratch pad is not used for this flash part.
<4>96345GW prom init
<4>CPU revision is: 00028000
<4>Primary instruction cache 8kb, linesize 16 bytes (2 ways)
<4>Primary data cache 4kb, linesize 16 bytes (2 ways)
<4>Linux version 2.4.17 (root@tsirikul1.usr.com) (gcc version 3.1) #1 Mon Sep 15 09:50:52 CDT 2003
<4>Determined physical RAM map:
<4> memory: 00fc0000 @ 00000000 (usable)
<4>On node 0 totalpages: 4032
<4>zone(0): 4032 pages.
<4>zone(1): 0 pages.
<4>zone(2): 0 pages.
<4>Kernel command line: root=/dev/mtdblock0 ro
<4>bcm_console_setup
<4>Calibrating delay loop... 92.97 BogoMIPS
<4>Memory: 14436k/16128k available (1092k kernel code, 1692k reserved, 76k data, 40k init, 0k highmem)
<4>Dentry-cache hash table entries: 2048 (order: 2, 16384 bytes)
<4>Inode-cache hash table entries: 1024 (order: 1, 8192 bytes)
<4>Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
<4>Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes)
<4>Page-cache hash table entries: 4096 (order: 2, 16384 bytes)
<4>Checking for 'wait' instruction...  unavailable.
<4>POSIX conformance testing by UNIFIX
<6>Linux NET4.0 for Linux 2.4
<6>Based upon Swansea University Computer Society NET3.039
<4>Initializing RT netlink socket
<4>Starting kswapd
<4>Module bcm6345_cons.c v1.1 Sep 15 2003 09:51:57
<4>brcmboard: brcm_board_init entry
<4>block: 64 slots per queue, batch=16
<6>PPP generic driver version 2.4.1
<6>NET4: Linux TCP/IP 1.0 for NET4.0
<6>IP Protocols: ICMP, UDP, TCP, IGMP
<4>IP: routing cache hash table of 512 buckets, 4Kbytes
<4>TCP: Hash tables configured (established 512 bind 1024)
<6>Linux IP multicast router 0.06 plus PIM-SM
<6>NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
<4>Ebtables v2.0 registered<6>NET4: Ethernet Bridge 008 for NET4.0
<4>VFS: Mounted root (cramfs filesystem) readonly.
<4>Freeing unused kernel memory: 40k freed
<4>Algorithmics/MIPS FPU Emulator v1.5
<4>atmapi: init_module entry 0xc0006060
<4>blaadd: blaa_detect entry
<4>adsl: adsl_init entry
<6>var 1.0 initialised
<4>Broadcom BCM6345A0 Ethernet Network Device v0.1 Sep 15 2003 10:03:21 External PHY
<4>eth0: MAC Address: 00:C0:49:D3:97:D6
<4>wl0: hardware configuration BE_PCMCIA EBI_DMA 
<4>wl0: Broadcom BCM43XX 802.11 Wireless Controller  3.31.12.0 (Compiled in . at 14:14:47 on Aug 21 2003)
<4>BcmAdsl_Initialize=0xC0017418, g_pFnNotifyCallback=0xC0024C10
<4>Status read failure: len=12, st.code=0, st.value=0
<4>AdslCoreHwReset: AdslOemDataAddr = 0xA0FDF5E0
<6>device eth0 entered promiscuous mode
<6>br0: port 1(eth0) entering listening state
<6>br0: port 1(eth0) entering learning state
<6>br0: port 1(eth0) entering forwarding state
<6>br0: topology change detected, propagating
<7>atm_connect (TX: cl 1,bw 0-0,sdu 1524; RX: cl 1,bw 0-0,sdu 1524,AAL 5)
<2>eth0 Link UP.
<6>device nas17 entered promiscuous mode
<6>br0: port 2(nas17) entering listening state
<6>br0: port 2(nas17) entering learning state
<6>br0: port 2(nas17) entering forwarding state
<6>br0: topology change detected, propagating
<2>ADSL G.994 training
<2>ADSL G.992 started
<2>ADSL G.992 channel analysis
<2>ADSL link up, interleaved, us=320, ds=1216